THINNER FOR CAR BODY LIQUID RUBBER 1 X 500 ML

PRODUCT INFORMATION Our newly developed FOLIATEC.com Carbody Spray Film is the next generation of removable car body coatings. Carbody Spray Film is suitable not only for professional, large-area applications on complete vehicles, but also for rims, mirrors, motorcycles, and much more. FOLIATEC.com is one of the first manufacturers to offer ready-to-spray metallic colors. Ready for use with spray nozzles between 2.0 and 2.5 mm, Carbody Spray Film can be applied like a regular lacquer to car bodies using a spray gun or our FOLIATEC.com spray system. Best of all, the applied coating can be easily removed at any time without any tools. Ready to use, sufficient for partial car coating and full coating of two-wheelers. Very good opacity, attractive appearance, and a smooth spray finish. Protection against scratches, salt, weather conditions, and chipping of the original paint. UV resistant. Applicable to any non-absorbent surface. Easy to remove. 1 liter is sufficient for a maximum of approximately 2 square meters. Product tip: Optimal in combination with our FOLIATEC.com Carbody Spray Film Thinner to adjust the viscosity. Magic Green-Purple tip: We recommend applying two coats of matte black with a 10-minute flash-off time, then applying two coats of Magic Green-Purple. Important: The matte black must be dry before applying Magic Green-Purple. Depending on the amount of thinner, it lasts approximately 3 hours. APPLICATION: All easily removable parts of the car should be detached. Mask off all surfaces that should not be coated. Mask off rubber seals with FOLIATEC.com Easy Up Tape (item no. 79920). You should also protect wheel wells and the underside of the vehicle from overspray. Clean and dry the surface to be sprayed, including edges, then degrease with FOLIATEC.com Carbody Spray Film Pre-Filter (item no. 79934). After cleaning, remove any remaining dust with a duster. Application with the FOLIATEC.com spray system: Apply FOLIATEC.com Carbody Spray Film in 4 to 5 generous coats. On horizontal surfaces (roof or hood), work slowly and at level 1 or 2: set the quantity control on the spray gun handle to level IIII. On vertical surfaces, work at a medium pace and level 2. If necessary, reduce the quantity control on the spray gun handle. Use only in suitable workshops and garages. Reduce ventilation if working in a spray booth. Spray gun application: Apply FOLIATEC.com Carbody Spray Film in 4 generous coats at medium speed. Use a 2 to 2.5 mm spray nozzle at a pressure of 3 to 5 bar in a suitable spray booth. Flash for 10 minutes after each coat. Note: The Carbody Spray Film is completely dry after 60 minutes. After 24 hours, the vehicle is ready to drive again. For detailed information, refer to the instruction manual.